Shell and Tube Heat Exchanger Chemical Vapor Solvent Condenser Steam Water Heat Exchanger Steam Water Separation Condensation-The steel processing parts are mainly used in machinery manufacturing, shipbuilding, steel structure, abrasive tool processing and other industries.
Condensors are used to liquify vapors; the condensation heat (or latent heat) is absorbed by a coolant (often water) Usually plate-and-shell condensors are used (plate-and- frame units may show vapor leakage), with four main types:1. Horizontal / condensation on the outside of the tubes 2.
heat exchangers and Ref. 14 for condensers. Details of construction practices are described by Saunders.58 The Tubular Exchanger Manufacturers Association (TEMA) provides a manual of standards for construction of shell and tube heat exchangers,1 which contains designations for various types of shell and tube heat exchanger configurations.
Chapter 2 - Refrigerated Condensers - US EPA(McCabe and Smith, 1976). Shell and tube condensers circulate the coolant through tubes. The VOCs condense on the outside of the tubes (i.e., within the shell). Plate and frame type heat exchangers are also used as condensers in refrigerated systems. In these condensers, the coolant and the vapor flow separately over thin plates.
Mar 15, 2017 · China Shell and Tube Heat Exchanger Chemical Vapor Solvent Condenser Steam Water Heat Exchanger Steam Water Separation Condensation, Find details about China Heat Exchanger, Spiral Wound Tube Heat Exchanger from Shell and Tube Heat Exchanger Chemical Vapor Solvent Condenser Steam Water Heat Exchanger Steam Water Separation Condensation
Service Testimonials
laser cutting process
¡°The laser cutting process uses the energy released when the laser beam irradiates the surface of the steel plate to melt and evaporate the stainless steel.¡±
¡°Grinding uses abrasive particles coated or press-embedded on the grinding tool to finish the machined surface (such as cutting) through the relative movement of the grinding tool and the workpiece under a certain pressure.¡±
¡°The laser cutting process uses the energy released when the laser beam irradiates the surface of the steel plate to melt and evaporate the stainless steel.¡±
¡°Grinding uses abrasive particles coated or press-embedded on the grinding tool to finish the machined surface (such as cutting) through the relative movement of the grinding tool and the workpiece under a certain pressure.¡±